Wilson Nozzles: Air Atomising Spray Nozzles

Air and Liquid Atomising Lance Assembly

Air and water supply inlet set @ 1.5bar,

trajecting critical mass atomise droplets for Dry Flue Gas desulphuration

Adjustable Air Liquid Atomising Nozzle

Adjustable air atomising assemblies combines air and liquid by knob adjustment. By changing the spray tip setup, different spray pattern such as full cone, hollow cone and fan can be attained.

Material : 316 stainless steel or brass.

Size :1/4" (Female) NPT

DOWNLOAD CAT - SUE_Air_Atomising.pdf

SUE series

With independent stream and control of Air and liquid inlet, the Air / Liquid Atomising Fan Spray External mix facilitates fine atomisation for liquid that contains abrasive suspended particles and is well suited even for viscosity
above 150 centipose. Spray Angle : 60 - 90 degrees cone.

Spray tip selection - Fan, Hollow, extra wide fan and full cone

DOWNLOAD CAT - SUK Air Atomising.pdf

SUK series

The liquid and air stream being dependent on each other, collide under pressure in the internal mixing chamber effecting a thorough mix before exiting the orifice. The Internal mix produces the finest atomisation possible in any Air and liquid atomiser. However, it is gets clog easily for liquid with viscosity above 150 centipoise.

Spray Angle : Wide angle 60 degrees to 90 degrees Cone

Large Critical Mass Air Atomiser for Dry Fog

With 3 to 5 bar of compressed air and Household water pressure of 5 bar.

Large critical mass of fine

mist / Dry Fog can be achieved with

our Air Atomiser

Model : SA307-6-holes tip.

Horizontal trajectory 5 to 8 metres

Download Cat: SA 1.pdf

Fine Oil Mist Atomising

Download Dwg : RII-15..pdf

RII 15 series Atomising nozzle with ruby Insert orifice for high velocity spray discharge to effect fine atomisation. Spray angle for 30 degree. Material : stainless steel c/w filter , Size : 1/4 inch Male NPT